Vax carpet washer repair.
Vax carpet washer not dispensing water.
In this video i show you how to remove and clean both sets of brushes on a vax dual power pro carpet washer.
There are a few other alternatives to try.
Does anyone have any ideas about how to fix it peter.
Getting competent advice from the vax chat on troubleshooter was a waste of time.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Our vax v 024 carpet washer now refuses to dispense water when the trigger is pulled.
Its most useful advice is to take off the dirty water tank turn on the motor and check the hole by the motor to see if it is sucking.
Pull the dirty water tank handle forward and lift the filter to remove.
Rinse the tank through with warm water and tip out.
To replace the nozzle line up the tabs on the nozzle with the tabs underneath the front of the carpet washer.
To cure this put a kettleful of hot water into the water tank and run the machine for a few minutes pressing the trigger on and off to give bursts of pressure to help shift the blockage.
Lift the nozzle release clip and pull the nozzle forward separating the tabs on the nozzle and carpet washer.
Ying tong iddle i po.
This is a fairly lengthy and detailed look at the replacement process of the pump responsible for the dispensing of the detergent in a vax carpet cleaner.
Twist to remove the dirty water tank cap.
If this does not solve it the answer is most likely that the pipes and valves inside the machine are blocked by congealed shampoo.
It was blowing rather than sucking.
Our instructional video shows you how to use the vax rapid power revive carpet cleaner.
Using the handle lift the tank off the machine.
Rinse the nozzle under water to remove dirt and debris.
Remove both tanks and tilt the carpet washer back.
